John-deere stx38 User Manual download pdf (Page 230)

5 - 66

3/20/97

REPAIR

POWER TRAIN

3. Install idler combination gear assembly (H) into

lower case half.

4. Measure air gap (J) between shim washer (I) and

face of case (K) (see Inspect Idler Combination

Gear Assembly).

5. When proper air gap is obtained, assembly should

drag slightly against feeler gauge.

Assemble Input Shaft/Pinion Gear Assembly:

IMPORTANT: DO NOT scratch or deform upper

case half bore when installing needle bearings.

1. Pack needle bearings (A and B) with grease before

installing.

2. Install lower needle bearing (B) with flat side of

bearing (with lettering) toward inside of case.

Press lower needle bearing in case bore until it is

recessed 3.3 mm (0.13 in.) (H) from inside bore

opening.

3. Install upper needle bearing (A) with flat side of

bearing (with lettering) toward outside of case.

Press upper bearing in case bore until it is flush—

0.76 mm recessed (flush—0.03 in. recessed) with

outside bore opening.

4. Pack cavities (G and H) with grease before

installing input shaft.

5. Install input shaft (E) (with keyway on outside of

case), large washer (I), small washer (J), bevel

pinion gear (K), and snap ring (L).

M42324

M42497

M42496

M42525

M42320

1 2 ... 225 226 227 228 229 230 231 232 233 234 235 ... 313 314

Comments to this Manuals

Alicia Cross 12 Jul 2025 | 21:17:32

Installing clutch spring, need a diagram.

Fred 15 Aug 2025 | 02:18:54

Great

John Jaeger 06 Jan 2026 | 22:35:47

Stx38 hydro need manual plz.

James Smith 03 Apr 2026 | 23:03:46

The

GUILLAUME MILLOT 08 Apr 2026 | 19:44:25

Good

John-deere stx38 User Manual Page 230

Comments to this Manuals

Related products and manuals for Special machinery John-deere stx38