John-deere GREENSTAR BZ100157 User Manual download pdf (Page 8)

Installation Instructions

OUCC002,000233C –19–12OCT06–1/2

Modify High Arc Spout

ZX1039636 –UN–12JUL06

ZX1039637 –UN–12JUL06ZX1039638 –UN–12JUL06ZX1039639 –UN–12JUL06ZX1039640 –UN–12JUL06

A—Fixing Screws

B—Fixing Screws

C—Template Z103666

D—Area to Cut

E—Drilling Holes

F—Brackets Z103667

On machines with old high arc type spout, proceed as

follows to install NIR sensor brackets:

1. On both sides of the spout, release the side wear plate

fixing screws (A) and rear wear plate fixing screws (B).

Remove and discard rear wear plate. Remove both

side wear plates.

2. Install template Z103666 (C) over spout as shown

using original hardware (A). Pull up template Z103666

screws (A).

3. Mark area (D) to cut a hole 102 mm (4.01 in.) diameter

then drill two holes 11x20 mm (0.43x0.78 in.) at

locations (E).

4. Install brackets Z103667 (F) on template Z103666 (C)

with four screws 19M7865 M8X16 and flange nuts

14M7298. Make sure brackets (F) are in contact with

spout sides then weld at front and rear of the brackets

(F) (see arrows) on spout.

IMPORTANT: Grind spout sides at locations where

weld will be carried out.

5. Remove template Z103666 (C) then finalize welding

process on top of brackets Z103667 (F) (see arrow).

Z103757 (13DEC06)

Installation Instructions

011507

PN=8

Continued on next page

1 2 3 4 5 6 7 8 9 ... 30

No comments

John-deere GREENSTAR BZ100157 User Manual Page 8