John Deere TY25864 User Manual download pdf (Page 10)

Safety

OURGP12,000010C –19–02JUN04–1/1

Personal Precautions

1. Wear complete eye protection and clothing

protection. Avoid touching eyes when working near

batteries.

2. Have plenty of fresh water and soap nearby, in

case battery acid contacts skin, clothing, or eyes.

3. Someone should be within range of your voice or

close enough to come to your aid when you work

near a lead-acid battery.

4. Avoid touching eyes while working with battery. If

acid enters eye, immediately flood eye with running

cold water for 15—30 minutes and get medical

attention immediately. If battery acid contacts skin

or clothing, wash immediately with soap and water.

5. Batteries generate explosive gases! NEVER smoke

or allow a spark or flame in the vicinity of battery or

engine. Always operate battery charger in an open,

well ventilated area.

6. Do not drop a metal tool onto the battery. It might

spark or short-circuit the battery or other electrical

part that may cause an explosion.

7. Remove personal metal items such as rings,

bracelets, necklaces, and watches when working

near a lead-acid battery.

8. Use the battery charger for charging LEAD-ACID

batteries only. The charger is not intended to supply

power to a low voltage electrical system other than

in a starter-motor application. Do not use the

battery charger for charging dry-cell batteries that

are commonly used with home appliances. These

batteries may burst and cause injury to persons or

damage to property.

9. NEVER charge a frozen battery.

10. Never allow battery acid to drip on charger when

reading specific gravity or filling battery.

11. Never set battery on top of battery charger.

12. Neutralize acid spills thoroughly with baking soda

before attempting to clean up.

OURGP12,000010E –19–02JUN04–1/1

Battery Charger Connection Precautions

CAUTION: Connect and disconnect DC

clamps only after removing AC cord from

electrical outlet.

Never allow battery charger clamps to touch

each other.

Do not connect both battery charger clamps

directly to the battery.

1. Locate battery charger as far from battery as cables

permit.

2. When connecting battery charger, attach one clamp

to battery and the other clamp to a grounding point

away from the battery.

3. Read the Controls and Operation section before

connecting the battery charger.

4. When connecting each clamp, rock or twist the

clamp back and forth several times to make a good

connection. Do not twist or rock the first clamp after

the second clamp has been connected.

05-6

091604

PN=10

1 ... 9 10 11 ... 84

Comments to this Manuals

No comments

John Deere TY25864 User Manual Page 10

Comments to this Manuals

Related products and manuals for Car battery chargers John Deere TY25864