John Deere AUTOTRAC OMPFP11320 User Manual download pdf (Page 15)

AutoTrac Controller—Raven

BA31779,0000223 -19-04AUG11-4/21

Continued on next page BA31779,0000223 -19-04AUG11-5/21

IMPORTANT: Read all instructions before calibrating

the AutoTrac Controller

AutoTrac calibration should completed without

an implement connected to the tractor to avoid

damage to the tractor or implement.

•

Drive tractor slowly at full throttle for approximately

2 to 5 minutes to bring hydraulic uid to operating

temperature before beginning calibration procedure.

•

Calibration procedure will require a large, open, level

surface to complete the required steps.

•

Calibration procedure must be completed prior to using

AutoTrac for the rst time.

•

Calibration procedure must be complete with a passing

status prior to using AutoTrac. If a passing status is not

achieved then AutoTrac will not work.

NOTE: At any time during calibration, the operator

may take control of the system by grabbing the

steering wheel or stopping the machine.

To begin calibration select Recalibrate Hydraulic System

button (C) form the Calibration Assistant Main screen.

PC13385 —UN—20APR11

Calibration Assistant Main Screen

A—Home

B—Reset controller to Factory

Defaults

C—Recalibrate Hydraulic

System

D—Exit Calibration Assistant

To proceed with the calibration process select yes (B) to

proceed or select no (C) to cancel.

A—Home

B—Yes

C—No

PC13387 —UN—20APR11

Recalibrate Hydraulic System

25-2

090811

PN=15

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 71 72

Comments to this Manuals

No comments

John Deere AUTOTRAC OMPFP11320 User Manual Page 15

Comments to this Manuals

Related products and manuals for Cars John Deere AUTOTRAC OMPFP11320